1/32 Fully Cowled Mini 4WD #44 Beat Magnum Premium (AR Chassis)

[Premium specifications that emphasize speed with large diameter tires and AR chassis] This is a plastic model assembly kit of a high-performance racer that adopts a shaft drive four-wheel drive. The Beat Magnum Premium is a premium version of the Beat Magnum, the fourth machine of one of the main characters of the mini 4WD manga “Bakusou Kyodai Let’s & Go!!”, Hoshino Go. The front and rear fenders have become smaller to accommodate the large diameter tires, and the coil springs and dampers for the dragon suspension attached to the cockpit sides appeal to high-performance driving. As befits a high-speed machine, the large rear wing with flaps is a flat type that reduces air resistance. The body color is white. A special metal-like sticker tightens the form. The AR chassis is made of metallic gray ABS resin, and the under panel and diffuser are made of blue low-friction resin. The fluorescent green five-spoke large diameter wheels are equipped with slick tires. [AR Chassis] The AR chassis is not only aerodynamic, but also has all the elements necessary for Mini 4WD racing, such as ease of maintenance, rigidity, and expandability. Equipped with air intakes for the battery and motor, it efficiently cools the inside of the chassis with the wind while running, preventing power loss due to heat. In addition, it is equipped with plastic bearings made of low-friction resin, which reduces drive loss and achieves weight reduction. The underpanel and diffuser can be removed with one touch, allowing you to replace the battery and motor without removing the body. In addition, a rear skid bar is standard equipment. When passing through a slope course such as a slope section, the skid bar made of low-friction resin comes into contact with the course surface to control the machine’s posture and prevent it from going off the course. Comes with a 4.2:1 speed gear. [Basic specifications] ● Total length when completed 155mm ● Overall width 97mm ● Overall height 47mm ● Motor included ● Assembly is a snap-fit ​​type that does not require adhesive